This commit add basic support for Photonicat Board.
Flash into lede:
Run first: dd if=openwrt-xxx.img of=/dev/mmcblk0
Then brush the img file to sdcard and insert it,
the system will boot from above.
Note:
Since rockchip does not release any code to power up their
device, disabled emmc for now until we can remove rkbin.
* Update Makefile
Add Support For Rocktech MPC1903
* Add support for Rocktech MPC1903
* Add support for Rocktech MPC1903
* Update armv8.mk
* Add support for Rocktech MPC1903
* Add support for Rocktech MPC1903
* Update armv8.mk
* Update rk3399-mpc1903.dts
* Add support for Rocktech MPC1903
* Update rk3399-mpc1903.dts
* Add support for Rocktech MPC1903
* Add support for Rocktech MPC1903
* Update armv8.mk
* Delete mpc1903.bootscript
* Add rk3399-mpc1903.dts
* Add support for Rocktech MPC1903
* uboot-rockchip:fix r4se uboot sd card not bootable
this will cause uboot to fail to load the sd card at startup, and uboot can recognize emmc
* rockchip:fix r4se system loading prompt led
* add the previous one
* fix
The current target code is too chaotic, the patches are
messy and disorderly, and there are still many duplicate
code. Pack it back to half a year ago.
With this change you need have swig and libpython3-dev installed on
your host, which should be done already.
Signed-off-by: Tianling Shen <cnsztl@immortalwrt.org>
* uboot-rockchip: Fix doornet1dts
The dts refers to the official website uboot startup parameters
`arch/arm/mach-rockchip/rk3328/rk3328.c`---Fix boot order parameters,It is helpful for other devices to start emmc and sd normally
* Update 104-rockchip-rk3328-Add-support-for-EmbedFire-DoorNet1.patch
* Rockchip:Fix dtsi of doornet2
phy:
Modify phy timing;The manufacturer's board requires two timing modes: 125m and 25m ---stmmac_mdio.c stmmac_main.c
Among them, stmmac_main.c is added with 1.5 reset, and the compilation of other devices is not affected
emmc:
In emmc hs400 mode, the performance test effect is the same as hs200, so it is safer to reduce hs200
* Rockchip:Add doornet2 to overclock to 2.2GHz/1.8GHz
* Create 105-rockchip-rk3399-Add-support-for-EmbedFire-DoorNet2.patch
Modify the startup method: SD starts first, which is convenient for saving bricks. If there is no system in SD, it will automatically jump to the next emmc boot
* Update with kernel 5.4
* Update 992-rockchip-rk3399-overclock-to-2.2-1.8-GHz-for-NanoPi4.patch
Nobody ever updates PKG_RELEASE when changing devices or setup in
the various uboot-* packages. Use $(AUTORELEASE) so we still have
proper versioning there.
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Co-authored-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
