mirror of
https://github.com/coolsnowwolf/lede.git
synced 2025-04-19 03:43:29 +00:00
8061c8b8f9
* kernel: crypto: add atmel i2c hw accelerator support Signed-off-by: Tianling Shen <cnsztl@immortalwrt.org> * kernel: add led act/polarity select for rtl8221 phy Signed-off-by: Tianling Shen <cnsztl@gmail.com> * mediatek: add support for OpenEmbed SOM7981 Hardware specification: SoC: MediaTek MT7981B 2x A53 Flash: 256 MiB SPI-NAND RAM: 0.5/1 GB DDR4 Ethernet: 1x 1GbE, 1x 2.5GbE (RTL8221B) WiFi: MediaTek MT7976C USB: 1x M.2 B-Key GPIO: 26-Pin header UART: 6 GND, 8 TX, 10 RX (in Pin header) Button: Reset Installation: The board comes with a third-party custom OpenWrt image, you can upload sysupgrade image via LuCI directly WITHOUT keeping configurations. Or power on the board with pressing reset button for 5 second, then visit http://192.168.1.1 and upload -factory.bin firmware. Signed-off-by: Tianling Shen <cnsztl@gmail.com> --------- Signed-off-by: Tianling Shen <cnsztl@immortalwrt.org> Signed-off-by: Tianling Shen <cnsztl@gmail.com> |
||
|---|---|---|
| .. | ||
| ath10k-ct | ||
| bcm27xx-gpu-fw | ||
| bcm63xx-cfe | ||
| bpf-headers | ||
| broadcom-wl | ||
| button-hotplug | ||
| cryptodev-linux | ||
| dtc/patches | ||
| gpio-button-hotplug | ||
| gpio-nct5104d | ||
| gpio-nxp-74hc153 | ||
| ksmbd | ||
| lantiq | ||
| leds-ws2812b | ||
| linux | ||
| mac80211 | ||
| mt76 | ||
| mt7621-qtn-rgmii | ||
| mtk-eip93 | ||
| mwlwifi | ||
| nat46 | ||
| om-watchdog | ||
| r8101 | ||
| r8125 | ||
| r8126 | ||
| r8168 | ||
| rtc-rv5c386a | ||
| rtl8812au-ac | ||
| rtl8812au-ct | ||
| rtw88-usb | ||
| trelay | ||
| ubnt-ledbar | ||
| xr-usb-serial | ||