mirror of
https://github.com/coolsnowwolf/lede.git
synced 2025-04-19 03:43:29 +00:00
![]() Hardware: - SoC: MediaTek MT7981B - CPU: 2x 1.3 GHz Cortex-A53 - Flash: 128 MiB SPI NAND - RAM: 512 MiB - WLAN: 2.4 GHz, 5 GHz (MediaTek MT7976CN, 802.11ax) - Ethernet: 1x 10/100/1000/2500 Mbps WAN, 1x10/100/1000 Mbps LAN - USB 3.0 port - Buttons: 1 Reset button, 1 slider button - LEDs: 1x Red, 1x White - Serial console: internal test points, 115200 8n1 - Power: 5 VDC, 3 A Installation: The installation must be done via TFTP by disassembling the router. On other occasions Cudy has distributed intermediate firmware to make installation easier, and so I recommend checking the Wiki for this device if there is a more convenient solution than the one below. To install using TFTP: 1. Connect to UART. 2. With the router off, press the RESET button. While the router is turning on, the button should continue to be pressed for at least 5 seconds. 3. A u-boot shell will automatically open. 4. Connect to LAN and set your IP to 192.168.1.88/24. Configure a TFTP server and an OpenWrt initramfs-kernel.bin firmware file. 5. Run these steps in u-boot using the name of your file. setenv bootfile initramfs-kernel.bin tftpboot bootm 6. If you can reach LuCI or SSH now, just use the sysupgrade image with the 'Keep settings' option turned off. Signed-off-by: Luis Mita <luis@luismita.com> |
||
---|---|---|
.. | ||
airoha | ||
amlogic | ||
apm821xx | ||
arc770 | ||
archs38 | ||
armvirt | ||
at91 | ||
ath25 | ||
ath79 | ||
bcm27xx | ||
bcm47xx | ||
bcm53xx | ||
bcm63xx | ||
bcm4908 | ||
bmips | ||
gemini | ||
generic | ||
imx | ||
ipq40xx | ||
ipq95xx | ||
ipq806x | ||
kirkwood | ||
lantiq | ||
layerscape | ||
loongarch64 | ||
malta | ||
mediatek | ||
mpc85xx | ||
mvebu | ||
mxs | ||
octeon | ||
octeontx | ||
omap | ||
oxnas | ||
phytium | ||
pistachio | ||
qualcommax | ||
ramips | ||
realtek | ||
rockchip | ||
sifiveu | ||
siflower | ||
silicon | ||
sunxi | ||
tegra | ||
uml | ||
x86 | ||
zynq | ||
Makefile |